this guide is for win7.
This is the driver that communicates with the serial chip inside the monome. This is required before any software can 'talk' to the monome.
Important! FTDI seems to have the wrong drivers linked in the table. Download the executable which is correct, shown below:
you can access the most updated drivers from the above link.
serialosc translates between serial data (hardware) and osc messages (software).
run the installer.
be sure to have “Start serialosc service” checked!
Max by Cycling '74 isn't required to use the monome, but it is the most commonly used environment and fastest way to test your setup.
Please download the full version of Max (with the free trial). Never fear, you can use the Max Runtime version (included) that never expires, and it comes with a few handy patches the Runtime-only download doesn't.
Hint: don't start the clock on the full Max 30-day trial until you're ready to start authoring your own patches. Use the runtime instead.
This is a Max specific file that allows you to connect and configure your device with an application.
Move this file into your
C:\Program Files (x86)\Cycling '74\Max 6\Patches\
Note: If you can't find
/Max6/Cycling '74 instead.
windows will probably block OSC ports, so you need to either disable your firewall or create an exception for max6. you should be prompted for an exception:
Download monome_test. This is a Max patch designed to test input and output communication with a monome grid or arc.
Hint: drag the maxpat file onto MaxMSP Runtime to launch the runtime instead of the full version of Max. Or, launch the Max Runtime app and open the file from there.